Starting in 2001, the hull was created with insulating
foam and two steel rods
|
Starting in 2001, the hull was created with insulating
foam and two steel rods
|
|
| The Sail was constructed with insulating foam and dowel rods | |
| Here is the finished master of the hull and the sail | |
| This is my friend Darrell, doing the glass lay-up in the female mold that he made of the master | |
| Here is the first hull out of the mold (August 2002) and the rudders attached | |
| Here is the dive plane linkage... this area is very limited vertically so the "crankshaft idea" was created | |
| Missile deck after untold hours of scribing | |
| This is a working Missile for the Typhoon | |
| The Starboard Index lip installation (checks to see if you have enough clamps) | |
| The Pert antenna will be controlled by a pump (working on a microcontroller to take servo pulses and control the pump direction and to time motor on/off) | |
| Rudder linkages (These were home made on my new lathe) | |
| Here are the completed stern tubes | |
| 2006 - FINALLY got back into working on Sub's - Here is the prototype of the bow plane extension mechanism |
|
| The prop blade and hub for the left master next to a picture of the original | |